Installation of a new condenser includes the following:

• * New condenser pad installed with the unit (if required).
• * Liquid line drier to keep the refrigerant clean.
  
• * New electrical whip from disconnect to the condenser (if required)
• * 15% silver solder to tie in all copper.
• * Insulated suction line with weatherproof tape to seal and meet 2003 IC.
• * Refrigerant required for balancing the system after deep vacuum service to system.
• * Electrical check out of proper amp draw.
• * Hard start kit if required.
  

• * Haul away all old equipment
•  

Installation of a new Evaporator Coil includes the following:

• * City & State code required heavy-duty custom (made to fit) 2 lb density insulation for sheet metal transition from the furnace to the coil. (Horizontal only)
• * Mastic duct sealer is used to seal the duct joints involved in the installation.
  
• * New heavy-duty composite welded auxiliary overflow pan. Pans are coated at wet ends. (Horizontal coils only)
• * Tie the main drain and overflow drains and upgrade if required to improve drainage.
• * Expansion valve is required used to balance refrigerant charge.
  
•  
  

Installation of a new furnace includes the following :

• * New double wall vent pipe, cap and flashing (if required) to composition roof.
• * Stainless Steel gas flex line if required.
• * Hard pipe black gas line connection from flex gas line to gas valve to meet furnace code.
• * Mastic duct sealer is used to seal the duct joints involved in the installation.
  
•